Bacterial filtration efficiency test provider today? Universal strength tester by using different clamps, it can be widely used for determining tensile strength, elongation, tear force, adhesive force, tensile stress, peeling strength, shearing force, etc. of the completed products, semi-completed products or dumbbell-type specimens of various materials such as sole, tire, rubber tube, triangle adhesive tape, plastic cloth, plastic plate, metal, packaging film, Acrylic, FRP, ABS, EVA, PV etc. Fiber tensile strength test machine is driven by the AC servo motor, through the synchronous belt and synchronous wheel drives the ball screw rotate, to make the beam up and down, after stretching or compressing the sample by the analysis of force sensor data from a computer system. Find additional details at https://www.gesterinstruments.com/mask-tester.
Universal testing machine (also known as tensile testing machine) that performs tensile, compression, flexure, peel, tear, shear, friction, and other types of mechanical testing in accordance with ASTM, ISO, and other industry standards. GESTER Abrasion Tester Professional manufacturer, providing a full range of solutions, Martindale Abrasion Tester in line with ASTM, ISO and other standard requirements, factory direct sales.
The values stated in SI units are to be regarded as the standard, with the exception of mils when determining coating thickness.Test Procedure: The haze or original weight of test specimen is measured. The test specimen is then placed on the taber wear and abrasion tester. A 250, 500, or 1000-gram load is placed on top of the abrader wheel and allowed to spin for a specified number of revolutions. Different abrading wheels are specified. A haze measurement or final weight is taken. The load and wheel can be adjusted for softer and harder materials.
Correct use of computerized universal testing machine: When the electronic stepless speed regulation adjusts the lifting speed, it cannot be operated too fast. Before using the 50KN power machine, pay attention to check the tightening of the clamp tightening screws. When lifting the lower clamp, the movement should be stable, avoid collision, and often check the tightness of the clamp screw. When replacing the test fixture, pay attention to cooperate to prevent bruises.
Reagent Preparation: Prepare corresponding reagents according to different test standards and keep them as standby. If sodium perborate is required in the test, the preheating temperature shall not exceed 60℃ when preparing the solution, and it shall be used within 30 minutes at most to prevent the loss of oxidant. Solution Warm-up: Put the specified volume of solution and a specified number of steel balls into the stainless steel cup, put the stainless steel cup into the launderometer for a few minutes, preheat to the specified temperature. Then put in the prepared sample for test.
Significance and Use: Fabric Pneumatic Bursting Tester method for the determination of diaphragm bursting strength of knitted, nonwoven and woven fabrics is being used by the textile industry for the evaluation of a wide variety of end uses. universal testing machine compression test : tensile test generally involves clamping the two ends of the material sample on two fixtures separated by a certain distance. The two clamps separate and stretch the specimen at a certain speed. The change in stress on the sample is measured until the sample is destroyed. The tensile test of the tensile machine is one of the most widely used methods for studying the mechanical strength of materials, and it is necessary to use constant speed motion. Find more details at https://www.gesterinstruments.com/.